Suitable for borewell fittings, joining electrical conduit, drainage, agriculture and in irrigation piping
Step 1 : Cut the pipe
Step 2 : Remove burr, roughen and clean the outer surface of the pipe and inner surface of the socket
Step 3 : Check the dry fit of pipe & fitting. It should go up to end of the fitting easily.
Step 4 : Apply one coat of Solvobond PVC 503 evenly using suitable applicator on outer surface of the pipe and inner surface of the socket. Again apply second coat on pipe.
Step 5 : Twist the pipe 45°-90° while inserting into the socket for better spreading of Solvobond PVC 503 and hold for 30 sec.
Step 6 : Do not move joint for 10 minutes
Step 7 : Partially emptied container should be close immediately.
Low VOC
Meets ASTM D 2564 Standards
High burst strength
Solvobond PVC 503 is a medium-bodied PVC solvent cement used for joining and repairing PVC pipes and fittings.
It bonds PVC pipes and fittings used in borewell, drainage, agriculture and irrigation piping systems.
Roughen and clean the pipe and socket, apply two coats of Solvobond PVC 503, twist the pipe 45-90° while inserting, and hold for 30 seconds.
Do not move the joint for 10 minutes after application to allow the solvent cement to set properly.
Common applications include borewell fittings, electrical conduit joining, drainage, agriculture and irrigation piping.
Solvobond PVC 503 has high burst strength and meets ASTM D 2564 standards; specific heat-resistance figures are not listed.
Avoid using Solvobond PVC 503 on pipes or fittings other than PVC, as it is formulated specifically for PVC bonding.
Common mistakes include applying only a single coat instead of two, and moving the joint before the 10-minute set time.
Solvobond PVC 503 is a low-VOC, high-coverage solvent cement with high-pressure resistance that conforms to IS 14182 standards.
Store Solvobond PVC 503 in a dry place in its original, properly closed container at 2-40°C, and reseal partially used containers immediately.
Shelf Life: 2 years for tin container and 4 years for Coex pack from date of manufacture (Storage Temp 2-40°C) for
Storage: Product should be stored in a dry place in their original, properly closed containers at temperature between 2-40°C. Partially emptied container should be closed immediately.
Conforms to IS 14182
High coverage
High-pressure Resistance
Low VOC & Eco-friendly