Solvobond

• Medium bodied fast drying CPVC solvent cement
• For Potable water upto 82°C
• Low VOC
• High Solid Content
• Sustain High Pressure
• Resists algal & bacterial growth.
• Ideal product for Hot-Water plumbing

• Pipe assemblies recommended at temperature above 5°C. For CPVC Pipe thru 2” interference.
• Suitable for all kinds of PVC pipes & fittings upto 4″ diameter under pressure line and upto 6″ diameter of all class of pipes non pressure line.

• Cut the pipe

• Remove burr, roughen and clean the outer surface of the pipe and inner surface of the socket

• Check the dry fit of pipe & fitting. It should go up to end of the fitting easily.

• Apply Solvobond CPVC 707 evenly using suitable applicator on outer surface of the pipe and inner surface of the socket.

• Twist the pipe 45°-90° while inserting into the socket for better spreading of Solvobond CPVC 707 and hold for 30 sec.

• Wipe off excess cement.

• Partially emptied container should be close immediately.

• Allow 2 min to get good handling strength. 1 hr for cold water system upto 160 psi, 6 hr for hot water system upto 100 psi @82°C. For pipe size 1.5” (50 mm) or larger, higher temperature & pressure longer cure time is require.

* Minimum requirement of Hydrostatic burst strength as per ASTM F493 is 400 PSI

2 years from date of manufacture (Storage Temp 2-40°C)

Product should be stored in a dry place in their original, properly closed containers at temperature between 2-40°C. Partially emptied container should be closed immediately.