Solvobond
SOLVOBOND PVC 501 is regular bodied PVC solvent cement for PVC pipes & fittings upto 6” diameter. It is suitable for conduit & low-pressure and drainage systems
MEETS: ASTM D-2564 Standard.
- Regular bodied PVC solvent cement
- Low VOC
- Low Viscous-High Coverage
- Sustain High Pressure
- PVC pipes and fitting for low pressure and drainage. Assembly recommended at temperature above 5°C. Allowable gap: 0.3 mm. interference: 0.2 mm
- Borewell fittings
- Joining Electrical Conduits
-
Cut the pipe
-
Remove burr, roughen and clean the outer surface of the pipe and inner surface of the socket
-
Check the dry fit of pipe & fitting. It should go up to end of the fitting easily.
-
Apply one coat of Solvobond PVC 501 evenly using suitable applicator on outer surface of the pipe and inner surface of the socket. Again apply second coat on pipe.
-
Twist the pipe 45°-90° while inserting into the socket for better spreading of Solvobond PVC 501 and hold for 30 sec.
-
Do not move joint for 10 minutes
-
Partially emptied container should be close immediately.
NO PRESSURE TEST FOR
- 24 hrs on < 63 mm pipe
- 48 hrs on 75-160 mm pipe
| Properties | Results | |
|---|---|---|
| Physical state | Low Viscosity | |
| Color | Colorless | |
| Viscosity at 25°C (Cps) | 70-120 | |
| Hydrostatic burst strength* (Joint curing 2hr atRT) (ASTM D-2564) | >700 PSI (In 2” pipe) min | |
* Minimum requirement of Hydrostatic burst strength as per ASTM F493 is 400 PSI
2 years from date of manufacture (Storage Temp 2-40°C)
Product should be stored in a dry place in their original, properly closed containers at temperature between 2-40°C. Partially emptied container should be closed immediately.
-
Metal Container:
50 ml, 118 ml, 237 ml, 473 ml & 946 ml
Mandatory and recommended industrial hygiene procedures should be followed whenever our products are being handled and processed. For additional information please consult the corresponding product data sheets and the brochure “Hygienic precautions for handling plastics products”.
