Solvobond

• Medium Bodied uPVC Solvent Cement
• Solvent Cement for use with un-plasticized PVC Pipes & Fittings
• Low VOC
• Ideal product for cold water plumbing

• uPVC Pipe assemblies recommended for industrial, irrigation, electrical conduit, plumbing, including PVC foam core pipe size thru 6” dia. Interference fit. Sch. 80 thru 4’ dia.
• Suitable for Domestic Plumbing, Agriculture Pipeline, Boring Application and Door Manufacturing

• Cut the pipe

• Remove burr, roughen and clean the outer surface of the pipe and inner surface of the socket

• Check the dry fit of pipe & fitting. It should go up to end of the fitting easily. Use Solvobond primer if require

• Apply first coat of Solvobond uPVC 606 evenly using suitable applicator on outer surface of the pipe and inner surface of the socket. Apply second coat on pipe till socket depth

• Twist the pipe 45°-90° while inserting into the socket for better spreading of Solvobond uPVC 606 and hold for 30 sec.

• Wipe off excess cement and leave the surface untouched for one hour for perfect bonding

• Partially emptied container should be close immediately..

• Allow 5 min to get good handling strength. 30 min for strength upto 160 psi interference fit upto 2” For pipe size 2” or larger, temperature below 15°C & higher pressure longer cure time is require.

* Minimum requirement of Hydrostatic burst strength as per ASTM F493 is 400 PSI

2 years from date of manufacture (Storage Temp 2-40°C)

Product should be stored in a dry place in their original, properly closed containers at temperature between 2-40°C. Partially emptied container should be closed immediately.