SOLVOBOND CPVC 707 is yellow coloured medium-bodied CPVC solvent cement for joining CPVC pipes & fittings. It is recommended for potable water piping as well as pressurized pipes. It can withstand temperature upto 82°C. It can be used without primer.
MEETS: ASTM D-2846 & F-493 Standards.
Cut the pipe
Remove burr, roughen and clean the outer surface of the pipe and inner surface of the socket
Check the dry fit of pipe & fitting. It should go up to end of the fitting easily.
Apply Solvobond CPVC 707 evenly using suitable applicator on outer surface of the pipe and inner surface of the socket.
Twist the pipe 45°-90° while inserting into the socket for better spreading of Solvobond CPVC 707 and hold for 30 sec.
Wipe off excess cement.
Partially emptied container should be close immediately.
Allow 2 min to get good handling strength. 1 hr for cold water system upto 160 psi, 6 hr for hot water system upto 100 psi @82°C. For pipe size 1.5” (50 mm) or larger, higher temperature & pressure longer cure time is require.
|Physical state||Low Viscosity|
|Viscosity@ 25°C (Cps)||500-1000|
|Hydrostatic burst strength* (Joint curing 2hr @82°C) (ASTM F-493)||>1000 PSI (In 2” pipe) min|
|Sustain Pressure Strength (ASTM F-493)||Sustain at 364 PSI for 4 Hrs @ 82°C|
* Minimum requirement of Hydrostatic burst strength as per ASTM F493 is 400 PSI
2 years from date of manufacture (Storage Temp 2-40°C)
Product should be stored in a dry place in their original, properly closed containers at temperature between 2-40°C. Partially emptied container should be closed immediately.
50 ml, 118 ml, 237 ml, 473 ml & 946 ml
Mandatory and recommended industrial hygiene procedures should be followed whenever our products are being handled and processed. For additional information please consult the corresponding product data sheets and the brochure “Hygienic precautions for handling plastics products”.