Solvobond uPVC 606 is fast setting solvent cement for joining uPVC pipes & fittings for low pressure and drainage system. It can be used for uPVC pipes transporting potable water as well as for materials like PVC, Acrylic & ABS.
MEETS: ASTM D-2564 & IS: 14182-1994 Standards.
Cut the pipe
Remove burr, roughen and clean the outer surface of the pipe and inner surface of the socket
Check the dry fit of pipe & fitting. It should go up to end of the fitting easily. Use Solvobond primer if require
Apply first coat of Solvobond uPVC 606 evenly using suitable applicator on outer surface of the pipe and inner surface of the socket. Apply second coat on pipe till socket depth
Twist the pipe 45°-90° while inserting into the socket for better spreading of Solvobond uPVC 606 and hold for 30 sec.
Wipe off excess cement and leave the surface untouched for one hour for perfect bonding
Partially emptied container should be close immediately..
Allow 5 min to get good handling strength. 30 min for strength upto 160 psi interference fit upto 2” For pipe size 2” or larger, temperature below 15°C & higher pressure longer cure time is require.
|Physical state||Low Viscosity|
|Viscosity@ 25°C (Cps)||500-800|
|Hydrostatic burst strength* (Joint curing 2hr @RT) (ASTM D-2564)||>700 PSI (In 2” pipe) min|
* Minimum requirement of Hydrostatic burst strength as per ASTM F493 is 400 PSI
2 years from date of manufacture (Storage Temp 2-40°C)
Product should be stored in a dry place in their original, properly closed containers at temperature between 2-40°C. Partially emptied container should be closed immediately.
50 ml, 118 ml, 237 ml, 473 ml & 946 ml
Mandatory and recommended industrial hygiene procedures should be followed whenever our products are being handled and processed. For additional information please consult the corresponding product data sheets and the brochure “Hygienic precautions for handling plastics products”.