Bondtite Quick

Resiquick can be used in any general purpose application like repairing of any auto assembly, crockery, jewelry, clock, plastic, toy, electronics & home applicationes etc.

• Better Flow & penetration
• Colorless
• Cost effective due to multiple usage as three enclosures are present
• Higher shelf life as material is filled under inert atmosphere

• Make sure the surfaces to be bonded are clean and dry.
• For opening of ampoule, hold the ampoule in vertical position and tap the cap so that whatever material present in neck area should be drop down.
• Now twist the cap to open the ampoule.
• Dispense a drop or drops to one surface only. Apply enough quantity to achieve a thin film after compression. Curing time can vary based on amount of glue and type of surface glued. Excess glue can cause delayed or bond failure.
• Press parts together and hold firmly for a few seconds. Good contact is essential. An adequate bond develops in less than one minute based on the substrate.
• Wipe off excess adhesive from the top of the nozzle and recap Resiquick to the three re-closures given on the cap. If left uncapped, may deteriorate by contamination from moisture in the air.
• Because Resiquick condenses by polymerization, sometimes whitening will occur on the surface of the ampoules when humidity is high.

• Not recommended for polyethylene, Polypropylene EPDM Rubber, Silicone rubber, Teflon, styrofoam etc.

• 10 months from date of manufacturing when stored in the original unopened pouch. Use within 30 days once opened. Without warranty as storage condition will affect the shelf life