Trubuild

• Concealed roofs, parking decks, bathroom, toilet, kitchen, balconies and planters
• Swimming pools, water tanks and reservoirs
• Concrete foundations, basements wall and lift pits
• Any other concrete, cement or masonry surface subject to damage from moisture
• Slurry can be applied by brush or trowel. Do not dilute with water. recommended coverage rate is approximately 1.65-1.75kg/m2/2 coat (minimum two coat should be applied)
• Allow the slurry to cure for at least 4-6 hour before applying a second coat

• Quick drying.
• Easily applied by brush or trowel
• Flexible
• Excellent adhesion to concrete and masonry substrates.
• Non-toxic substances
• Environmentally friendly - free Volatile Organic Compound (VOC)
• Can be applied on damp surface
• Can exhibit Positive and negative water hydrostatic pressure 5 bar and 3 bar respectively

Surface Preparation

• Allow new concrete and masonry substrate to fully cure prior application
• All surfaces must be free from oil, grease, wax, dirt or any other form of foreign matter, which might affect adhesion. Spalled Concrete must be sound before applied
• All surfaces must be free from oil, grease, wax, dirt or any other form of foreign matter, which might affect adhesion. Spalled Concrete must be sound before applied
• Substrate should be reaching a "Saturated Surface Dry" (SSD) condition (damp, without standing water)

Mixing

• Using mechanical mixer, slowly add Powder part to Liquid part in a clean container until a smooth and homogenous slurry mixture is achieved
• Allow the mixed slurry to stand for 5-10 minutes for releasing air-trapped during the mixing prior to application. Mixing material must be use within recommend pot life(40-45min)

Application

• Slurry can be applied by brush or trowel. Do not dilute with water. recommended coverage rate is approximately 1.65-1.75kg/m2/2 coat (minimum two coat should be applied)
• Allow the slurry to cure for at least 4-6 hour before applying a second coat

Curing

• After application of 2nd coat, allow the system to air cure for 5 to 6 hours. This should be followed by moist curing by sprinkling /spraying of potable water for 24 hours. After moist curing, the surface should be allowed to air cure for 3 to 5 days before covering it with screed
• Trubuild Aqualock requires at least 7 days curing before filling spas, swimming pools and water tanks with water as well as mock-up or ponding test

• 1.65-1.75 kg/m2 /2 coats (min 2 coats recommended).
• Coverage always Depending upon the type and quality of the substrate.

• Shelf life is 12 Month from the date of manufacturing, in unopened, Store in a cool & dry
• Place in unopened condition away from direct sunlight
• Use mask, nose cover and hand gloves during application
• Clean hand with soap water after application