Trubuild

• Press Trubuild CFP-425 firmly into the crack with a spatula or putty knifes and level with the surface. Internal & external plastered brick masonry wall cracks of up to 5 mm width.

• Consistency - Paste form, without sagging
• Ease of application- Easy to apply by putty knife similar to conventional putties
• Flexibility - Flexible, therefore does not crack & accommodates minor movements in cracks
• VOC - Water based with very low voc hence eco-friendly.
• Application advantage - Can be applied on damp surfaces but not on cracks with running water.
• Paint ability - Over coat able by any type of polymer-based paints, after 24 hours.
• Bonding - Excellent adhesion with cementitious surface.
• Durability – Excellent resistance to UV & atmospheric conditions.

Surface Preparation

• Surface must be free from dust, oil, grease, and loose particles etc. Moisten the surface before applying Trubuild CFP-425. Fine hair line cracks must be widened up to 1 mm minimum by using scrapper and then filled
• For filling Trubuild CFP-425 on the internal surface, existing POP or painter’s putty must be removed till plaster surface is exposed
• For porous surfaces, apply primer coat prepared with Trubuild CFP-425 and water in 1:1 proportion over the crack. Fill Trubuild CFP-425 when the surface is tacky and not dried completely.
• Press Trubuild CFP-425 firmly into the crack with a spatula or putty knifes and level with the surface. Care must be taken to avoid formation of cavities or bubbles during application. Allow it set for 24 hours and then apply another coat of Trubuild CFP-425.
• Further POP or painter’s putty application can be taken up once it is fully dry
• Not for application in cracks in structural members, expansion joints & separation gaps
• Fine hair line cracks must be widened with ‘V” groove up to 1 mm minimum and Then fill.
• Care must be taken to avoid formation of cavities or bubbles during application.
• Allow it set for 24 hours and then apply another coat of Trubuild CFP-425

Coverage

• 25-30 running meter/kg (for a depth of 5mm and width of 5 mm).

• Should not be used for cracks more than 5 mm thick
• Not for application in cracks in structural members, expansion joints & separation gaps.
• For application below 10°C, drying time will be delayed

12 months from date of manufacturing in unopened containers.

Storage at cool & dry place, away from sun heat. For information and advice on the safe handling, storage and disposal of chemical Products, users shall refer to the most recent Material Safety Data Sheet containing, physical, ecological, and toxicological and other safety related data