Trubuild

• To fill static cracks of 3 to 5 mm.
• To level undulation on un plastered or plaster celling’s and walls prior to painting.
• To provide smooth finish to brick, stone, and concrete
• For crack filling – Fill the mixed paste into the crack by spatula or putty knife blade. Fill excess material and tool it by putty knife blade pressing against crack so that air voids get filled. By wet finger tool the surface of material in to a concave nature by pressing against joint edges
• For Surface levelling – The mixed smooth paste should be applied by painter blade on the dampened wall or ceiling. The material should be applied at the desired thickness in bottom- to -up fashion to avoid blade marks. For multiple coat applications the previous coat should be allowed to cure for minimum 6 hrs. The subsequent coat should be at the right angle to the previous coat

• Adhesion - Strong adhesion to common building substrates
• Easy to use - It is a do it yourself product & requires only onsite addition of water
• Requires only addition of water on - site at the time of usages.
• As surface leveller before painting it reduces paint consumption and increases the life of the paint making it economical

• Ensure the joints edges to be neat and sound. Make sure that surface is clean & free from standing water. The surface should be free of loose debris
• Contaminations of oil, grease or bitumen should be completely cleaned
• In normal conditions Trubuild CFP-525 does not require a primer. However, in critical areas water based acrylic or SBR based primer can be used depending on the severity of surface and application
• Mixing ratio of Trubuild CFP-525 to water varies with respect to area of application
• For filling deep holes and cracks-reduce the water quantity to get a thicker pasty consistency
• The final mixed product would be of dough consistency paste. In case further soft consistency is required, measured quantity of water can be used

Coverage

• 37.5 running meter per kg (for a depth & width of 5mm)

• Trubuild CFP-525 is for static joint filling only. Suitable for cracks less than 5mm width
• It does not accommodate any movements and thus it is not suitable for dynamic cracks
• For outside use the Trubuild CFP-525 must be coated over with exterior paint to prevent water penetration

Shelf life is 12 months from date of manufacturing in unopened pouch.

Store at cool & dry place, away from sun heat.