Bondtite Wood Adhesives

• PVC sheet rolls to plywood
• PVC edge banding
• Ply board to charcoal sheet

• Excellent compatibility with PVC & Acrylic to provide best fixing solution
• Sufficient strength with long & durable bonding with PVC edge banding.
• Excellent spread ability and high coverage to save cost.
• Excellent heat resistance for heat prone applications

• Surface to be bonded should be dry clean and free from oil or grease.
• First, apply glue uniformly on backside of PVC laminate sheet and then apply the glue on the plywood /MDF, Particleboard and spread it uniformly.
• For PVC Edge Banding Tape, apply glue only on plywood / MDF/Particle board and spread the glue uniformly on the edge with the help of spreader/ knife of spatula
• Open time 10-15 minute under standard operating condition.
• Before the adhesive film dries up bring the PVC sheet or edge banding tape in contact to glue coated plywood /MDF surface & make the proper alignment.
• Apply hand pressure on the laminated surface using a wet squeezed cloth to remove any air entrap and avoid the bubble. Excess glue oozing out gets removed softly and carefully using the cloth or cotton.
• Press the edge bend joint for 2-5 minutes under the manual hand pressure. Use the masking tape to hold the joint firmly.
• Leave the laminated sheet in ambient condition to set .the handling strength is to obtained within 4-6 hr, however full strength will be developed after 24 hr @ room temp.

12 months from date of manufacturing in a sealed pack.